![]() The official instructions mention taking the wiring harness to an R3 interface under the front seat and then on to the BDC in the front footwell. A laptop with the latest E-Sys and PSDzdata installed and an ENET cableįor my car (and many others) the official MINI instructions are wrong.Ratchet with 8mm and 10mm sockets (and an extension bar is handy too for disconnecting the battery).VERY SMALL flathead screwdriver (to slide out existing wiring from pins) - Ideally a jeweller's screwdriver. ![]() Cable pull (used to route wiring through some tight/awkward areas of the car).Total cost: Approx £160 (excluding bumper trim pieces or PDC hole cutter) ![]() I haven't priced these as I was also installing the JCW pro diffuser at the same time, and ordered it with the PDC holes pre-cut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |